News Center

Promote the sustainable development of enterprises by technological innovation and expanding industry applications

Installation method of servo feeder


Release time:

2024-02-04

Author:

Source:

The servo feeder is more convenient and easier to operate than other mechanical feeders in terms of adjustment and control. When in use, it has a higher and more accurate feeding advantage, thus replacing the old air feeder. Below for everyone to introduce the installation method of servo feeder.

  Servo feederIt is more convenient and easier to operate than other mechanical feeders in terms of adjustment and control. When in use, it has a higher and more accurate feeding advantage, thus replacing the old air feeder. Below for everyone to introduce the installation method of servo feeder.

The servo feeder has good operability, and the operability of the servo feeder is better than that of everyone. Therefore, when you use it, you only need to use a high-definition CNC touch screen, which is simple to implement. Although its advantages are also more. However, there is also a lot of relevant information involved in the use. For example, when it is installed, it must also drill and tap 4 tooth holes on the side of the press platen according to the set position and size of the mounting plate, and fix the mounting plate on it. Then the main part is hoisted with a lifting rope. At this time, the key between the sliding plate and the mounting plate is centered, and the main body is fixed on the mounting plate with two matching screw bolts. If you can't install it yet, you must find a professional person to help you finish it. Of course, when the height and horizontal position of the feeder are inconsistent with the stamping of the die, the NC feeder slide plate will have an adjustment amount of about 100mm to adjust at this time. At this time, the two screw bolts on the slide plate can be loosened. It is suggested that everyone must adjust the bolts fixed on the mounting plate when installing the servo feeder, so as to change the horizontal position of the feeder, once in position, tighten the screws.

Therefore, it is very important to install the servo feeder. In addition, it is also necessary to remind the operator to fix the mold, ensure that the mold is perpendicular to the roller direction, and install a relaxed position on the punch slider. And also in the appropriate parts of the punch to install the electric control box and proximity switch, and check whether it is working properly.