News Center

Promote the sustainable development of enterprises by technological innovation and expanding industry applications

Which positions need to be adjusted for the servo feeder


Release time:

2024-02-04

Author:

Source:

The servo feeder often needs to replace different materials for production according to different stamping products during use. However, most companies use automated production lines to improve production efficiency and product output, and reduce labor costs. Let's take a look at which positions can be adjusted to make the servo feeder work better?

  Servo feederIn the process of use, it is often necessary to replace different materials for production according to different stamping products. However, most companies use automated production lines to improve production efficiency and product output, and reduce labor costs. Let's take a look at which positions can be adjusted to make the servo feeder work better?

1. CNC roller servo feeder baffle wheel width scheduling:

When the servo feeder presses different products, the applicable raw material width may be different. At this time, it is necessary to reasonably arrange the spacing of the block wheel so that the width of the block wheel matches the material. Turn and loosen the fixing screw of the blocking wheel, clamp the material at right angles to the stamping die when the material is fed into the machine head, then adjust the blocking wheels on both sides to the appropriate positions of the materials on both sides, and then lock the stop wheel screws Fix it.

2. The feeder has a long use time and high strength, and the motor transmission belt will be loose or worn and needs to be replaced. If the belt is loose, it must be adjusted in time to avoid slipping during transmission. First loosen the fixing wheel screw of the pressing belt, then tighten the fixing wheel to a suitable pressure, and then tighten the screw. If it needs to be replaced, the same applies. Note that the belt can not be too tight, otherwise it will shorten the life of the belt.

3. CNC rollerServo feederAdjustment of feeding height:

When changing the stamping die, the height of the lower die of each stamping product may be different. At this time, the CNC roller servo feeder must be adjusted according to the height of the lower mold. FeedingMachineThe lifting plate on the back has a certain adjustment position. First loosen the 4 fixing screws of the fixed hanging plate (adjust, do not loosen all), then fix and loosen the fixing nuts on the lifting screws, adjust the screw rod to the corresponding height according to the current height of the lower mold (counterclockwise down, Clockwise up), after adjustment, lock the adjusting nuts and the screws on the Feida hanging plate.

4. CNC roller servoFeederAdjustment of pressing force:

  Servo feederWhen stamping products, due to the different material and thickness of the raw materials, it is necessary to adjust the compression spring to achieve the appropriate pressure. Excessive pressure during adjustment will cause material deformation and the stamped product cannot be used. If the pressure is too small, the roller will not be able to compress the material, causing slippage and unable to accurately transport the material. Staff only need to adjust the feedingMachineThe two pressure springs on the top can be rotated clockwise to increase the pressure, and the counter pointer is rotated to reduce the pressure.