News Center

Promote the sustainable development of enterprises by technological innovation and expanding industry applications

What should be checked after the servo feeder material slips


Release time:

2024-02-04

Author:

Source:

Nowadays, many companies have ordered servo feeders in order to improve the efficiency of production. Generally, they will see it in many factories. To be honest, this product is still very useful. Before, we also introduced some problems that it often encountered when adapting. Next, the editor will also talk about the phenomenon of slipping of servo feeder materials.

Nowadays, many companies have ordered servo feeders in order to improve the efficiency of production. Generally, they will see it in many factories. To be honest, this product is still very useful. Before, we also introduced some problems that it often encountered when adapting. Next, the editor will also talk about the phenomenon of slipping of servo feeder materials.

Today, with the continuous progress of science and technology, the application of machines is becoming more and more extensive. Most people have never seen many things. It is precisely because of these devices that the efficiency of a factory has been improved and the cost has been reduced. For people in the stamping industry, they cannot do without the servo feeder. We will have a series of problems in actual use, especially for some novices, it is more necessary to understand. In general, material slippage is the most common thing. From the perspective of the industry, this is a relatively troublesome problem. As long as this happens, the materials will not be delivered to the location and the location will be inaccurate. How should this phenomenon be handled.

First of all, you have to find out the real reason and see what caused it. The staff should check the cylinder management of the pneumatic device and check that the air pressure is insufficient. If the air pressure is too low, the pressure spring is insufficient when clamping the material. If it is too thick, it is easy to make the material slip. At this time, another air pipe must be connected to the cylinder on the solenoid valve, and it will have thrust. Then check whether the power spring of the feeding leveling roller is qualified. Haute that meets the requirements will not have any problem. Its feeding speed should also be tested. In order to prevent slipping, its load is also tested.

The above content is the small series for everyone to bring about the servo feeder sliding situation how to solve some of the methods. This kind of situation is actually more troublesome. In order to prevent its occurrence, it is necessary to do a series of checks. If you encounter this kind of situation, don't worry, as long as the technicians carry out the tests according to the specified requirements. The knowledge points in this area are introduced here today, hoping to help you.

15996339737525.jpg