News Center

Promote the sustainable development of enterprises by technological innovation and expanding industry applications

Servo feeder two of the most common problems!


Release time:

2024-02-04

Author:

Source:

Now more and more mechanical equipment. These devices are much closer than the original ones, saving time and effort to use, which is enough to show that our country's science and technology and industry are making rapid progress. Today we would like to introduce the servo feeder for you, and explain some common problems about it.

Now more and more mechanical equipment. These devices are much closer than the original ones, saving time and effort to use, which is enough to show that our country's science and technology and industry are making rapid progress. Today we would like to introduce the servo feeder for you, and explain some common problems about it.

Servo feeder is often seen as a machine. It is used in many places. To put it bluntly, it is a commonly used material conveyor. With this thing, the production efficiency of the enterprise can be improved more quickly, which is really a greatly reduced cost for an enterprise. It is for these reasons that it is used in many places. In the process of using the most common first problem is the service feeder feeder is not allowed to do? For this matter to talk about, you have to look at the material thickness handle is not pressed, as long as it does not slip on the line. Then check the pneumatic relaxation of the feeder, check whether the pressure is normal and whether the coil fed is on the same level as the mold. When you also look at the transmission gap, if it is too large, you need to tighten the belt properly.

There is a second question when the servo feeder is in operation, that is, how the servo feeder performs multi-stage feeding? In fact, there are many things that need to be understood when the machine equipment is in operation. Of course, it is the same. If you encounter this, you have to enter the setting screen of the servo feeder. There are three sets of length settings in it. It is OK to go here. For example, the first thing to send is 50mm, then 100mm, and finally 150mm. Just operate according to this length on its touch screen. Set the number of segments and set the speed in screen 2, even if it is completed.

These are the problems that often occur in the process of using the servo feeder. We have made a detailed introduction for you today. Hope for some of the relevant personnel have some help. If you encounter other things in the future, you can also find a technician to understand, so as to avoid unnecessary operations. In short, these difficulties are often seen, and it is good to master these common sense things in advance.

15996339882419.jpg