News Center

Promote the sustainable development of enterprises by technological innovation and expanding industry applications

Pressing machine tells the relevant knowledge of safety regulations of punching machine?


Release time:

2024-02-04

Author:

Source:

A punch press is a punch press. In domestic production, the stamping process has the advantages of saving materials and energy than traditional machining, high efficiency, low technical requirements for operators, and various mold applications can produce products that cannot be achieved by machining. Therefore, it has more and more uses.

PunchIs a stamping press. In domestic production, the stamping process has the advantages of saving materials and energy than traditional machining, high efficiency, low technical requirements for operators, and various mold applications can produce products that cannot be achieved by machining. Therefore, it has more and more uses. Below follow the stamping machine to see its safety regulations knowledge!
1. The transmission parts exposed to the outside of the press must be equipped with protective covers. It is forbidden to drive or test the vehicle without opening the protective cover.
2. Before driving, check whether the main fastening screw is loose, whether the mold is broken, whether the operating mechanism, automatic stop device, clutch and brake are normal, and whether the lubrication system is blocked or lack of oil. If necessary, you can drive an empty car for testing.
3. To install the mold, the slider must be opened to the bottom dead center, the closing height must be correct, and eccentric load should be avoided as much as possible; the mold must be firmly fixed and pass the pressure test.
4. Attention must be paid in the work. It is strictly forbidden to place hands and tools in dangerous areas. Small parts must be operated with special tools (tweezers or feed mechanism). When the die sticks to the blank, it can only be released with a tool.
5. If you find that the press is running abnormally or there is an abnormal sound (such as knocking sound, cracking sound), please stop feeding the paper immediately and check the cause. If the rotating part is loose, the control device is malfunctioning, and the mold is loose and defective, please stop and repair it.
6. Every time the workpiece is punched, the hand or foot must leave the button or pedal to prevent misoperation.
7. If there are more than two people, you should order someone to drive and pay attention to coordination. Before leaving work, the mold should be put down, the power supply should be disconnected, and necessary cleaning should be carried out.
The above is the stamping machine editor introducedPunchI hope you can know more about the relevant knowledge of safety regulations.