News Center

Promote the sustainable development of enterprises by technological innovation and expanding industry applications

Is the feeder expensive? What is the working principle of the three functions of the feeder?


Release time:

2024-02-04

Author:

Source:

Is the feeder expensive? What is the working principle of the three functions of the feeder? Servo feeder adopts three functions of uncoiling and leveling feeding. In order to reduce production costs and improve efficiency, enterprises are increasingly adopting automated production. I believe many people know that a punching machine uses a triple feeder. Automated production equipment

  Feeder PriceIs it expensive? What is the working principle of the three functions of the feeder?

Servo feeder adopts three functions of uncoiling and leveling feeding. In order to reduce production cost and improve efficiency, enterprises are increasingly adopting automatic production. I believe many people know the automatic production equipment of a punching machine with a triple feeder. I really don't know much about the working principle and function of the triple feeder. Is the feeder expensive? Is it good? Today we will popularize relevant knowledge for everyone.

First of all, let's talk about the uncoiling part of the feeder. The uncoiling machine is a support table that fixes the roll on the unfolding part of the main shaft of the rack and supports the inner diameter of the roll. During automatic operation, the spindle can rotate intermittently to unwind and discharge through the control command of the material ring. Including spindle expansion part, pressure part, limit wheel part, material ring control part.

Then we talk about the feeder feed ring control material ring for intermittent transport of materials. A buffer length needs to be set between the uncoiler and the leveling feeder to absorb the impact of the intermittent feeding action of the feeder. Loop, detect, and send the detection signal back to the uncoiler, the spindle motor speed control the uncoiler, the uncoiler spindle motor is in the ON/OFF state, which is convenient for maintaining proper material circulation, the loop control system is controlled by three groups of photoelectric control The area is the high-speed area, the middle area is the slow area, and the bottom stop area.Feeder Priceexpensive is not expensive? Mainly depends on the cost of this piece, generally good machine, control ring is the highest cost, if this piece is not designed well, then it will seriously affect the use effect and service life of the product, so we must pay attention to this place.

Finally is the feeder horizontal feeder part. The flattening feeder is a device that conveys a certain number of correction rollers to the punching machine through the feeding roller after the material ring supported by the uncoiler is formed, obtains the stamping synchronization signal, and eliminates the bending deformation of the material through the feeding roller. In addition, the leveling feeder is designed and manufactured as a device on the punch production line, with the main purpose of eliminating rolls. When there is a local elongation on the material, it is sometimes not completely corrected. The feed mechanism is located at the end of the leveling mechanism. After leveling, the belt roller is fed synchronously, and the feeding is realized by PCL control input length.

Through the practical application of the feeder, it is shown that the reasonable AC servo system can meet the requirements of fast response speed and high speed accuracy of the control system, and the maximum accuracy of the actual application position control is about ± 0.1mm, which can avoid the cumulative error. The control system can be used for the production of high-precision open cold-formed steel products, especially similar to the shelf column products, that is, the vertical and side of the cold-formed steel with high-precision requirements for the hole on-line pre-punching cold-formed forming production line.