ZHEJIANG YITIAN PRECISION MACHINERY CO.,LTD
Safe Operation of Cheapest Eccentric Mechanical Power Press Machine
According to the different machine types and processing requirements of the press, formulate targeted and practical safety operation procedures, and carry out necessary job training and safety education. The user unit and operator must strictly abide by the regulations and operating procedures of the safety instructions provided by the design and manufacturing unit, and use and overhaul correctly. The general safety operation requirements of Cheapest Eccentric Mechanical Power Press Machine are as follows:
Before starting the equipment, check whether the operating part, clutch and brake of the press are in effective state, whether the safety protection device is complete and easy to use, and whether there is any abnormality in each part of the crank slider mechanism. Necessary measures should be taken immediately if any abnormality is found, it is not allowed to run with a disease, and it is strictly forbidden to disassemble and damage the safety device. Before the official operation, it must go through an idling test run, and it can only work after confirming that all parts are normal.
Before starting the machine, all unnecessary items on the workbench should be cleaned to prevent people from being injured by driving vibration or hitting the switch to cause the slider to start suddenly. Tools must be used for operation, and it is strictly forbidden to directly reach into the mold mouth to take objects by hand, and hand tools must not be placed on the mold.
When adjusting the position of the workpiece in the die mouth area or removing the workpiece stuck in the mold, the feet must leave the pedal. When multiple people operate the same press, there should be a unified command, and the signal should be clear. Wait for the other party to make a clear response and confirm to leave the danger zone before acting. If there is a sudden power failure or the operation is completed, the power should be turned off, and the manipulator should be restored to the clutch neutral position, and the brake should be in the braking state. When overhauling and adjusting the press and when installing, adjusting, and disassembling the mold, it should be carried out when the machine tool is disconnected from the energy source (such as electricity, gas, liquid) and the machine tool is stopped, and a pad is placed under the slider for reliable support. Cheapest Eccentric Mechanical Power Press Machine Warning on the sign at the start switch.