这是描述信息
这是描述信息

ZHEJIANG YITIAN PRECISION MACHINERY CO.,LTD

+86-574-86198812, 86198845

language
中国
韩国
韩国
韩国
韩国
韩国

News Center

Precautions for the installation of customized metal press machine

2022-01-28 11:24

Customized metal press machine here is a punch produced with a steel plate welded body. The customized metal press machine is generally composed of upper die, upper die holder, lower die holder, edge slope, reverse side pressing block, guide plate, guide post and many other parts. Its design principle is that circular motion drives linear motion for energy conversion. Based on the main motor, it first drives the flywheel, and then drives the gear, crankshaft, connecting rod and other components to run through the clutch, so that the slider moves in a straight line. The transmission structure of the punch mainly includes the fuselage, the crankshaft, the slider, the upper die punch, the lower die frame, the female die plate, and the die cavity. The transmission structure is installed on the fuselage, the cam on the crankshaft, the connecting rod installed on the fuselage that can slide up and down, the compression spring connected to one end of the connecting rod, the swing rod and the ejector rod; one end of the swing rod is movable with one end of the connecting rod The other end of the swing rod is connected to one end of the ejector rod, and the other end of the ejector rod is connected to the lower die punch through the top plate. In daily production and use, customers not only need to understand the performance and characteristics of the customized metal press machine, but also need to know some precautions for the installation and disassembly of the customized metal press machine, in order to facilitate maintenance in case of future problems.

customized metal press machine

Precautions for installation of customized metal press machine:

1. Check whether the accessories and wearing parts are complete according to the packing list of the customized metal press machine. At the same time, the press should be placed in a dry place for three to four days to remove the moisture in the motor and electrical equipment. If necessary, use the instrument to measure and check. Whether the electrical insulation is good and reliable.

2. Pour the foundation according to the foundation map. After the foundation is solidified, place the 100-ton fixed-table punch on it securely. Use a spirit level to check the levelness of the 100-ton punch work table. The deviation of each 1000 mm length should not be greater than 0.3 mm.

3. After the customized metal press machine is leveled, install the anchor bolts, pour concrete into the square hole, and start it after the concrete is completely solidified.

4. After the customized metal press machine is installed, use kerosene to clean the anti-rust grease on the surface of the equipment. When cleaning, be careful not to damage the paint surface. At the same time, clean the oil holes, oil passages and oil cups. Do not use metal objects or oil during cleaning. emery cloth. Then you should check whether the ground wire is connected properly.
 

Copyright © 2019 Zhejiang Yitian Precision Machinery Co., Ltd.

All rights reserved.浙ICP备19009580号 Powered by www.300.cn

这是描述信息

+86-574-86198823, 86198812

Copyright © 2019 Zhejiang Yitian  Precision Machinery Co., Ltd.

浙ICP备19009580号 Powered by www.300.cn