News Center

Promote the sustainable development of enterprises by technological innovation and expanding industry applications

How to Solve the Partial Material Problem of Servo Feeder


Release time:

2024-02-04

Author:

Source:

Servo feeder deviation refers to the phenomenon that the delivered material belt deviates to a certain side, which will cause the problems of inaccurate feeding and die mispunching. It needs to be solved in time to avoid damage to the die and unqualified production.

  Servo feederBias refers to the phenomenon that the delivered material belt deviates to one side, which will cause the problems of inaccurate feeding and die mispunching. It needs to be solved in time to avoid damage to the die and unqualified production.

There are two reasons for the bias of the servo feeder: one is the deviation caused by the uneven pressure adjustment of the left and right pressure of the pressing spring. The solution is very simple, only the pressure of the pressing springs on both sides needs to be adjusted evenly according to the material thickness; The second is that the material slips during feeding, which needs to be solved step by step.

  Servo feederPartial material, if the feeding process appears slippage phenomenon, mostly because the material is too thick, need to be solved in three steps:

1. Increase the pressing force of the pressing spring to ensure that the material can be completely pressed. When adjusting the pressing force spring, it is necessary to check whether the spring color is yellow or green. Yellow is yellow. The compression ratio of yellow spring is large, but the pressure is small. If it is yellow, contact the after-sales personnel of the punch feeder factory to replace it with green spring. (Make sure that the material thickness is within the applicable range of the machine)

2. InspectionServo feederWhether the air intake pipe is connected, if so, connect another air pipe to the solenoid valve. The servo feeder can also achieve the relaxation function by connecting an air pipe, but if the material is too thick, you need to connect an air pipe to the cylinder on the solenoid valve, so that the cylinder will have thrust, so that the roller on the servo feeder It can be clamped tighter to prevent slipping.

3. The material is thick and its own weight is too heavy. As the feed port is pulled backward, it causes slippage. At this time, under the premise of ensuring the feeding speed, it is necessary to minimize the waiting interval, reduce the back pull load of the feed port, and solve the problem of slippage. When using thick materials, it is very common for the material to be too heavy. Customers can consult after-sales personnel to determine a reasonable waiting interval.