News Center

Promote the sustainable development of enterprises by technological innovation and expanding industry applications

Punching machine tells the level of punch adjustment matters needing attention?


Release time:

2024-02-04

Author:

Source:

There is no need to feed during the debugging process, but first adjust the guide screw on the guide plate upwards, and then slowly adjust the punching hammer to the bottom dead center by moving in inches. At the same time, pay special attention to the guide plate. If the floating rod is pressed too low, the floating rod will bend or break. When starting the punch feeder for continuous punching, please make sure to turn the speed adjustment screw of the feeder clockwise, and the slider will be slightly slower, so you can see whether the slider hits the nylon spacer and The length fine adjustment screw moves back and forth.

We did talk a lot about punches. In order to enhance everyone's understanding and understanding of the punch, then let's talk about the matters needing attention when adjusting the level of the punch, followedstamping machinesmall make up a simple understanding to see it!
1. There is no need to feed during the debugging process, but first adjust the guide screw on the guide plate upward, and then slowly adjust the punching hammer to the bottom dead center by moving in inches. At the same time, pay special attention to the guide plate. If the floating rod is pressed too low, the floating rod will bend or break. When starting the punch feeder for continuous punching, please make sure to turn the speed adjustment screw of the feeder clockwise, and the slider will be slightly slower, so you can see whether the slider hits the nylon spacer and The length fine adjustment screw moves back and forth.
2. In the test machine, the slider will move back and forth. If it only touches the nylon washer but not the length adjustment screw, it means that the floating rod has not fallen deep enough, so the guide screw on the punch should be slowly lowered. If the slider only touches the length adjustment screw and does not touch the nylon washer when the slider moves back and forth, it is because the floating rod has fallen too deep and the bow/guide screw on the punch needs to be slowly adjusted upward.
3. If the slider moves between the length adjustment screw and the nylon washer and the distance between the two sides is equal, turn the speed adjustment screw counterclockwise to make the slider speed normal, and you can touch the slider when reciprocating the nylon washer and the washer ring.
To sum up, it isstamping machineXiao Bian tells us: You can know more about how to adjust the level of the punch.