News Center

Promote the sustainable development of enterprises by technological innovation and expanding industry applications

How to synchronize feeder and punch?


Release time:

2024-02-04

Author:

Source:

Feeder is a machine that relies on the force of machine movement to transport the material. The feeder referred to in this article refers to a coil supply machine suitable for continuous production and continuous supply. The cooperative relationship between the feeder and the punch is mainly reflected in the supply distance, supply time, and relaxation time. The following is a brief introduction to the three common feeders that are commonly used.

Feeder is a machine that relies on the force of machine movement to transport the material. The feeder referred to in this article refers to a coil supply machine suitable for continuous production and continuous supply. The cooperative relationship between the feeder and the punch is mainly reflected in the supply distance, supply time, and relaxation time. The following is a brief introduction to the three common feeders that are commonly used.

送料机

1. Air feeder

The feeding distance increases or decreases the feeding size with the loading and unloading separation ring, and finally adjusts the length adjustment screw. When the striking belt installed on the stamping slider touches the floating rod, the feeder starts feeding action. The effect of adjusting the feeding time can be achieved by adjusting the pressing length of the screw of the beating rod.

2. High-speed roller feeder

The supply time and supply length are controlled by the eccentric referee. The general supply time is 9 o'clock (270 degrees) to 3 o'clock (90 degrees)

(1) When the punch is stopped at 9 o'clock, rotate the eccentric referee so that the eccentric referee overlaps the groove center line and the connecting rod pivot line. In other words, the supply time is from 9 to 3 o'clock. If the punch stops at 12 o'clock, the eccentric referee will be 90 degrees vertical to the slot and link.

(2) If the punch stops at 8 o'clock, please repeat the above actions. In other words, the supply can be adjusted freely from 8 o'clock to 2 o'clock.

(3) The relaxation time of the material can be adjusted by adjusting the relaxation adjuster. In order to feed the paper length more accurately, the end of the inner guide rail of the mold and the relaxation device must be aligned. Due to the different length of the guide tip inside each mold, it is necessary to cooperate with the site.

3. Three-in-one feeder

The feeder is equipped with a control panel, which can directly set the paper feed step, which is very convenient. The matching punch usually has a control cabinet, which can directly set the supply angle and the relaxation angle.

Finally, when we use the punch feeder, what should we pay attention to in our work? The punch feeder is the most advanced industrial manufacturing equipment, and its operation contains many operating specifications and rules. Therefore, we will explain the punch feeder needs to pay attention to the actual work.

When using a punch feeder, you need to pay attention to when working

1. Generally, it is strictly prohibited for more than two people to operate at the same time. If there are special requirements, they should be specially responsible for commanding and specially responsible for foot control.

2. It should be operated by professional designated personnel. It is strictly forbidden to act as an agent with others during the operation. The learning operator should be carried out under the guidance of the teacher.

3, punch feeder work can not be overloaded.

4. Safety operation inspection must be carried out before starting, check the integrity of the punch feeder protection device, start for 2 minutes first, check the softness and flexibility of its operation, and remove the debris in the workshop.