News Center

Promote the sustainable development of enterprises by technological innovation and expanding industry applications

Analysis of Common Reasons for Return of Servo Feeder


Release time:

2024-02-04

Author:

Source:

Servo feeder has attracted much attention from the society since its appearance. Because of its high degree of automation, accurate feeding and low failure rate, many enterprises choose to use this machine.

Servo feederSince its emergence, it has attracted much attention from the society. Because of its high degree of automation, accurate feeding and low failure rate, many enterprises choose to use this machine.

When using this equipment, you will inevitably encounter some problems. Next, the editor will briefly introduce it to you.

Why?Servo feederDuring production, the material will go backwards? The main reason is that the feeder loosens the angle adjustment error, which is usually caused by improper operation or setting error of the operator. The relaxation angle is too wide, which makes the gap between the roller materials too large, causing the material to go backwards. There are two ways to relax the servo feeder. One relaxation method must be based on the material thickness and must be based on the material thickness and equipment requirements. Correct adjustment.

In addition, it has been used for a long time. Due to the long-term operation of the equipment, it is not possible to carry out customized maintenance and cleaning in time. Foreign matters and sundries are mixed in the servo feeder, resulting in damage and wear of the equipment.Servo feederCommon causes of abnormal problems.

Shun9sLUSkuPK6ug-85bpg.jpg

Other FAQs:

1Over-feeding or over-tightening of material pressing spring

Reason: The pressing spring is over-fed or cannot be too tight.

Solution: Adjust the pressure spring to the right pressure

2Fixed stamping times, short material delivery

Reason: foreign body in the gear part

Solution: Remove the foreign matter stuck in the gear

3Deviation of delivered materials

Reason: the pressure spring is not tight left and right

Solution: Lock the left and right pressing springs to the same

Zhejiang Yitian Seiko Machinery Co., Ltd. is located in Ningbo. The company was established on July 17, 2018. It has a large and large number of precision CNC machining equipment, various precision testing instruments, and a full set of physical and chemical facilities and other advanced quality control methods. The company's main products are steel frame punching machine, high-speed mesh hole machine,Servo feeder, Taiyida punch, high-speed punching machine, high-speed precision punch, feeder, stamping machine, etc. Customers in need are welcome to come and consult.